Whether you're building a premise network, a wireless access point, or an IP camera, a Cat6A field termination plug is the perfect tool for you. A Cat6A field termination plug is a toolless, reusable assembly that makes it quick, easy, and consistent to connect Cat 6A cables. It can be used to terminate both stranded and solid conductor cables. It's also ideal for IP-enabled devices, and is compatible with all Cat 6A networks. Moreover, it is designed to meet TIA-568.2-D component performance requirements for Cat 6A networks.
The first step in termination is to connect your network cable to a patch panel. Then, you'll need to pull the cable between two points. To do this, you'll need to make sure the connectors on each strand of your cable are attached to the correct strand. If you're using a thick outdoor shielded Ethernet cable, you may need to make a few cuts. This will make it easier for you to pull the cable through the patch panel.
The Cat6A field termination plug has a toolless assembly feature, which makes it easy to terminate oversized cable. In addition, the connector's strain relief boot serves as a locking mechanism for the plug, making it more secure. Moreover, it has an easy-to-use notch for alignment, and is compatible with all Cat 6A cabling. This plug is designed to perform well with Ethernet cable up to 10 Gigabit. It also comes with a dust cap for added protection.
The most important thing to do before termination is to make sure your conductors are in their proper wire slots. The conductor holder cap, or IDC cap, fits into the housing, and you'll want to press it down and press the notch in the front to make sure it's lined up with the plastic blue tab at the front of the housing. If the cap is too far away from the cable jacket, you may get a nick in the conductor. To prevent this, you'll want to untwist the cable as little as possible.